RDL HR-MP2A Dual Microphone Preamplifier - Power Supply Included

Inputs (2): XLR (3 pin, rear panel,1=GND, 2+, 3-) Input level (for +4 dBu output): -56 dBu to 0 dBu (maximum gain without pad, minimum gain with pad) Maximum Input Level: >+5 dBu (input pad disabled), +22 dBu (input pad enabled) Input Impedance: <1 kΩ balanced Phantom power: Switchable (both preamplifiers) 48 V phantom (IEC 1938: 1996-12) Input pad (2): 15 dB nominal (1 per preamplifier) Outputs (5): Each preamplifier (rear-panel): Detachable terminal block, Ââ€? TRS Mono sum (rear-panel): detachable terminal block Output level: +4 dBu balanced, -4 dBV unbalanced; +24 dBu maximum balanced Output Impedance: 150 Ω balanced Channels: 2 (1 and 2; may be used for stereo or as two separate mono preamplifiers) Gain Trim (2): 20 dB to 60 dB (front panel adjustable; one for each preamplifier) Frequency Response: 10 Hz to 70 kHz (+/- 0.5 dB) THD: Below noise floor CMRR: > 80 dB (50 Hz to 5 kHz) Residual Noise (below +4 dBu output): <-85 dB (20 Hz to 20 kHz, 40 dB gain, 150 Ω source); <-70 dB (20 Hz to 20 kHz, 60 dB gain, 150 Ω source) Crosstalk: Below noise floor Indicators (3): POWER LED (blue), CLIP (2, red) Power Requirement: 24 Vdc @ 165 mA (190 mA with phantom), Ground-referenced Mounting: Rack-mount using optional rack adapters such as HR-RA2; or operate free-standing (feet included) Dimensions: Height: 1.7 in, 4.3 cm; Length: 8.6 in, 20.6 cm; Depth: 4.59 in, 11.66 cm

• Two Independent Microphone Preamplifiers
• Balanced XLR Microphone Inputs
• Independent Controls for Each Preamplifier
• Front-Panel 20 to 60 dB Gain Control
• Switch-selectable 48 Volt Phantom